Comtrol UP DeviceMaster Installation - Manual (Page 37)

Hardware Installation and Configuration Guide: 2000451 Rev. J Configuring the DeviceMaster UP - 37
Configuring the DeviceMaster UP
4. Click Yes to upload the firmware.
5. Click OK to the advisory message about waiting until the DeviceMaster UP is
on-line and in the next minute the DeviceMaster UP unit or units should
display ON-LINE in the Status field.
6. Go to the appropriate Quick Start or User Guide for your protocol for
information about configuring the serial port or ports using the web page and
programming your PLCs. See
Locating Software and Documentation on Page 8
to locate the document for your protocol or refer to the installation CD shipped
with the DeviceMaster UP.
If you are planning on installing multiple DeviceMaster UPs, you may want to
use the Save/Load Configuration File feature in PortVision DX.
A configuration file can contain network settings and protocol settings. Refer
to the PortVision DX help system for information about saving and loading
configuration files.
7. After configuring the serial port characteristics and preparing your PLC
programs, you can use the next section in this guide, to attach the serial device
or devices.