Comtrol UP DeviceMaster Installation - Manual (Page 13)

Hardware Installation and Configuration Guide: 2000451 Rev. J Hardware Installation - 13
Hardware Installation
Installation Overview
Use the links below to locate installation procedures for the following models:
Note: If you have a DeviceMaster UP with 16-ports, use the DeviceMaster UP 16-
Port Hardware User Guide because the RJ45 connectors have different pin
outs.
Ports DeviceMaster UP Installation Procedure
1†
DB9 serial port with a
single Ethernet port
1-Port - Enclosed Installation on Page 14
1 Embedded system 1-Port - Embedded Installation on Page 16
2††
Screw terminal serial
ports 2-Port (Serial Terminal) 1E/2E
Installation
on Page 20
2‡ DB9 serial ports 2-Port (DB9) 1E/2E Installation on Page 22
4†
DB9 serial ports with dual
Ethernet†† ports
4-Port Installation on Page 24
† The DeviceMaster UP 4 -port models also include DB9 to RJ45 adapters.
†† One of the Ethernet ports on the DeviceMaster UP 2-port 2E and the 4-port is
a built-in downstream port for daisy-chaining DeviceMaster UP systems or
other network-ready devices.
Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1