Kenmore 385.16677 User Manual
Page 53
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hold the thread at both ends and tug gently to
ensure the thread is correctly inserted between
the tension discs. (If the presser foot lifter is
raised, the thread easily inserts between the
tension discs.)
(3) Left needle thread tension dial
4,5. Slide the thread from the bottom of front cover
thread guide (2) and the take-up lever cover
right to left.
6. Guide the thread over the front cover thread
guide (3).
Front cover thread guide (2)
Take-up lever cover
Front cover thread guide (3)
7. Insert the,iii|ii»îhïSilë left slot'ofThe;needier -
thread guide plate.
8. Raise the needle to its highest point and pass the
thread through the needle bar thread guide from
left to rightlii|ii|:s„,.^
9. Thread the left, needle IrOm front to back and pull
the thread abourtiliwfl'') from the eye of the
needle to the back.
(Z) Needle thread guide plate
(D Needle bar thread guide
(
9
) Left needle
- Gently pull all four thread ends towards the
back of the machine.
- Run threads under the presser foot and lower
the presser foot.
- Close side cover and looper cover.
- Turn handwheel toward you to chain off three
or four stitches.
The sewing preparation is now complete.
3
(6; -
4
.
5
.
0
"Si
42