Kenmore 385.16677 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjustment of
Cutting Width
When cutting width is too narrow or too wide against
seam width, adjust it as follows.
1. Turn off the power switch and unplug the
machine.
2. Open the looper cover and side cover.
3. Set the upper knife to down position
4. Turn the cutting width adjusting dial to get
desired position of lower knife.
(T)
Cutting width adjusting dial
(2) Lower knife
@ Standard setting
The cutting width of this model eah be adjusted
approximately 3.0 to 5.0 mm; from the right
needle position depending upon your sewing
needs or the fabric being used:..
. :
(The cutting widBilililld be'adjusted to get the
same resu.lts.a.s in drawing 4
When cuttin|iiijith is too narrow:
Turn cutting width:.adjusting dial ciockwise (A).
Lower knife w|i;|ii|g to right,;:- If
When cutting width is too wide.
Turn the cutting width adjusting dial counterclockwise
(B).
Lower knife will move to left.
5. Set the upper knife to up position.
6. Close the looper cover and side cover.
20