The position of thread guide bar, Attaching the spool holder cap and net, The position of thread guide bar ü – Kenmore 385.16677 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The Position of Thread Guide Bar
1. Pull the thread guide bar up as far as it will go.
2. Turn the thread guide bar so that the thread
guides are right above the spool pins.
(T) Thread guide bar
(D Thread guide
@ Stoppers
(4) Spool pin
* Make sure to lock the thread guide of the guide
pole in the correct position with the two stoppers.
Attaching the Spool Holder Cap and Net
1. When you use a small thread spool, pull gut .the "
spool holder from the spool pin vThenlplace the
spool with its slit side up, and put the spool fioider
cap on too cO -
(T) Spool holder;:
@ Spool ¡j I
@ Spool hoider cap
® Slit T-.oi.T
2. If the thread slips down from the spool during
threading and/or sewing, put a net on the spool as
illustrated to prevent jamming.
* The spool holder cap is an optional accessory.
0 Net
0 Spool pin
10