AERCO KC Series Equipped with C-More Controller for Massachusetts Only User Manual
Kc series gas fired water heating system
Printed in U.S.A.
REVISED 12/10
AERCO International, Inc.
• 159 Paris Ave. • Northvale, New Jersey 07647 • Phone: 201-768-2400 • FAX: 201-768-7789
KC series Gas Fired Water Heater
(Massachusetts)
GF-111-M
Operation and Maintenance Manual
Applicable to Serial Numbers G-02-530 and above
KC Series
Gas Fired
Water Heating
System
Natural Gas or Propane Fired,
Condensing and Forced Draft Hot Water Heater
1,000,000 BTU/HR Input
Patent No. 4,852,524
Table of contents
Document Outline
- KC-H-Cover-JAN-09_PN
- KC-H-TOC-12-11-06
- KC-H-Foreward-10-2-06-J
- KC-H-CH1-05-12-09
- KC-H-Ch2-05-19-09
- KC-H-Ch3-05-15-09
- KC-H-Ch4-GF111M--10-21-09-dsg-bb
- KC-H-Ch5-05-19-09
- SECTION 5 - SAFETY DEVICE TESTING PROCEDURES
- 5.1 TESTING OF SAFETY DEVICES
- 5.2 LOW GAS PRESSURE FAULT TEST
- 5.3 HIGH GAS PRESSURE TEST
- 5. 4 LOW WATER LEVEL FAULT TEST
- 5.5 WATER TEMPERATURE FAULT TEST
- 5.6 INTERLOCK TESTS
- 5.7 FLAME FAULT TEST
- 5.8 AIR FLOW FAULT TEST
- 5.9 SSOV PROOF OF CLOSURE SWITCH
- 5.10 PURGE SWITCH OPEN DURING PURGE
- 5.11 IGNITION SWITCH OPEN DURING IGNITION
- 5.12 SAFETY PRESSURE RELIEF VALVE TEST
- SECTION 5 - SAFETY DEVICE TESTING PROCEDURES
- KC-H-Ch6-GF111_12-09-10
- 6.1 MAINTENANCE SCHEDULE
- 6.2 Spark Ignitor
- 6.3 Flame Detector
- 6.4 COMBUSTION CALIBRATION
- 6.5 SAFETY DEVICE TESTING
- 6.7 BTU TRANSMITTER ASSEMBLY
- 6.8 MANIFOLD AND EXHAUST TUBES
- 6.9 HEAT EXCHANGER INSPECTION AND CLEANING
- 6.10 CONDENSATE DRAIN ASSEMBLY
- 6.11 LOW WATER CUTOFF PROBE INSPECTION AND CLEANING
- 6.12 HYDRAULIC ZERO NEEDLE VALVE ADJUSTMENT (C-More Control BOX)
- 6.13 FLAME STRENGTH MEASURMENT
- KC-H-Ch7_09-29-10
- SECTION 7- TROUBLESHOOTING GUIDE
- 1. Inspect feed forward (BTU transmitter) sensor for loose or broken wiring.
- 2. Check resistance of sensor to determine if it is within specification.
- 1. Measure the actual exhaust temperature and continuity of the exhaust sensor. If the exhaust temperature is less than 500 o F and the exhaust sensor shows continuity replace the sensor.
- 2. If exhaust temperature is greater than 500 o F, check combustion calibration. Calibrate or repair as necessary.
- KC1000 WATER HEATER TROUBLESHOOTING TABLE – Continued
- KC1000 WATER HEATER TROUBLESHOOTING TABLE – Continued
- KC1000 WATER HEATER TROUBLESHOOTING TABLE – Continued
- KC-H-App-A-11-25-08.GR
- KC-H-App-B
- KC-H-App-C
- KC-H-App-D-JULY-06
- KC-H-App-E--4-25-07
- KC-H-App-F-12-14-06
- KC-H-App-G-JULY-06
- KC-H-App-H
- KC-HTR-WARRANTY