Rice Lake Signal Conditioning Transmitter/Indicators User Manual
Sct weight transmitter, Installation & operator’s manual
This manual is related to the following products:
Table of contents
Document Outline
- Content
- 1.0 Introduction
- 2.0 Configuration
- 2.1 Calibration
- 2.2 Filter On The Weight
- 2.3 Zero Parameters
- 2.4 SCT20-DN (DeviceNet) Settings
- 2.5 Analog Output
- 2.6 Profibus Settings
- 2.7 SCT20-IP (EtherNet/IP) Settings
- 2.8 SCT20-IP (Ethernet TCP/IP) Settings
- 2.9 Serial Communication Settings
- 2.10 Outputs And Inputs Configuration
- 2.11 Test
- 2.12 Setpoints Programming
- 2.13 Reserved For The Installer
- 3.0 Operation
- 3.1 Semi-automatic Tare (Net/Gross)
- 3.2 Preset Tare (Subtractive Tare Device)
- 3.3 Semi-automatic Zero (Weight Zero-setting For Small Variations)
- 3.4 Peak
- 3.5 Alarms
- 3.6 SCT20-DN (DeviceNet)
- 3.7 Profibus
- 3.8 SCT20-IP (EtherNet/IP)
- 3.9 SCT20-TCP/IP (Ethernet TCP/IP)
- 3.10 Modbus/TCP
- 3.11 Modbus-RTU Protocol
- 3.12 ASCII Bidirectional Protocol
- 3.13 Fast Continuous Transmission Protocol
- 3.14 Continuous Transmission Protocol
- 3.15 Interface to Remote Display
- 3.16 Communication Examples
- SCT Weight Transmitter Limited Warranty
- For More Information
- SCT_TLB_Appendix.pdf