Mercedes-Benz CLS-Class 2014 COMAND Manual - Manual (Page 84)

on the map varies according to the icon.
You can select the icons that you want
COMAND to display.
If no points of interest are available, you will
see a message to this effect.
i You also see this message if you have
selected the No No Symbols Symbols menu item under
"Map display" (
Y
page 110).
X To confirm the message: press W the
COMAND controller.
X To select a POI: select Next Next or Previous Previous
and press W to confirm.
X To show details for the selection: select
Details Details and press W to confirm.
X
To change to the map: slide ZV the
COMAND controller.
You can move the map and select the map
section.
X To start route calculation: select Start Start
and press W to confirm.
A prompt appears asking whether the point
of interest should be used as the destina-
tion.
X Select Yes Yes or No No and press W to confirm.
i Cont. Cont. is displayed instead of Start Start when
Calculate Alternative Routes Calculate Alternative Routes is acti-
vated in the navigation menu
(
Y
page 93).
Personal POIs
General notes
i The use of personal POIs for displaying
traffic surveillance equipment is not per-
mitted in every country. Please observe the
country-specific regulations and adapt
your speed accordingly when driving.
Settings
Calling up the "Personal POIs" menu
X To switch to navigation mode: press the
Ø button.
X To show the menu: press W the COMAND
controller.
X Select Navi Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
X Select Personal POIs Personal POIs and press W to
confirm.
Displaying personal POIs on the map
The personal POIs are shown on the map with
an icon according to their category.
X Call up the "Personal POIs" menu
(
Y
page 82).
X Select Display Personal POIs On Map Display Personal POIs On Map
in the menu and press W to confirm.
You can select different categories.
82
Personal POIs
Navigation