Navi ga tio n, Destination input – Mercedes-Benz CLS-Class 2014 COMAND Manual User Manual
Page 73
COMAND controller and pressing W to
confirm.
X
Select
From Last Destinations
From Last Destinations
and
press W to confirm.
X
Select the desired destination by turning
cVd the COMAND controller and press
W to confirm.
The address entry menu appears again. The
destination address selected has been
entered.
X
To start route calculation: select
Start
Start
and press W to confirm.
Once the route has been calculated, route
guidance begins (
Y
page 69).
i
“Last destinations” memory
(
Y
page 107).
Entering a destination using the map
Calling up the map
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
Destination
in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
:
Current vehicle position
;
Crosshair
=
Details of the crosshair position
?
Map scale selected
X
Select
Using
Using Map
Map
and press W to confirm.
You will see the map with a crosshair.
Display = depends on the settings selected
in "Map information in the display"
(
Y
page 111). You can see the current street
name if the digital map contains the neces-
sary data, You can see the coordinates of the
crosshair if the geo-coordinate display is
switched on and the GPS signal is strong
enough.
Moving the map and selecting the des-
tination
X
To scroll the map: slide XVY, ZVÆ or
aVb the COMAND controller.
X
To set the map scale: as soon as you turn
cVd the COMAND controller, the scale bar
appears.
X
Turn cVd until the desired scale is set.
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
Destination input
71
Navi
ga
tio
n
Z