Mercedes-Benz CLS-Class 2014 COMAND Manual - Manual (Page 105)

X To show the menu: press W the COMAND
controller.
X Select Traffic Traffic by sliding ZV and turning
cVd the COMAND controller and press
W to confirm.
X Select Read Traffic Messages Auto‐ Read Traffic Messages Auto‐
matically matically and press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
Recalculating the route dynamically
The route types Dynamic Traffic Route Dynamic Traffic Route
and Dynamic TRF. Route Only After Dynamic TRF. Route Only After
Request Request take all relevant traffic messages
into account when calculating a route
(
Y
page 62).
If you have set the route type Dynamic Dynamic Traf‐ Traf‐
fic Route fic Route , COMAND guides you on the
updated route to your destination.
If you have set the route type
Dynamic Dynamic TRF. TRF.
Route Only After Request Route Only After Request , a prompt
appears.
You can now decide whether to:
R accept the route suggested by COMAND
R continue your original route
X
To accept the suggested route: press
W the COMAND controller.
X
To continue along the original route:
select Reject Reject by turning cVd the
COMAND controller and press W to con-
firm.
Destination memory
Home address (My Address)
Entering the home address via address
entry
X Proceed as described under “Adopting an
address book entry as a home address”
(
Y
page 103). Confirm My Address My Address by
pressing W.
X
To enter the home address for the first
time: confirm New Entry New Entry by pressing W.
X To change the home address: select
Change Change in the menu showing the home
address by turning cVd the COMAND con-
troller and press W to confirm.
X Confirm New Entry New Entry by pressing W.
X
In both cases, enter the home address as a
destination, e.g. as a city, street and house
number (
Y
page 64). Then, save the home
address (
Y
page 69).
Adopting an address book entry as a
home address
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X Select Destination Destination in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
X Select From Memory From Memory and press W to con-
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
Destination memory
103
Navi
gati
on
Z