Mercedes-Benz CLS-Class 2014 COMAND Manual - Manual (Page 149)

Adding the sender of a text message to
an address book entry
X
Press W the COMAND controller while the
text message is being displayed.
X Select Save Number Save Number and press W to con-
firm.
X Select Add Phone No. Add Phone No. and press W to
confirm.
X Proceed from the step "Select a number
category" (
Y
page 140).
Deleting a text message
X Select a text message in the text message
inbox by turning cVd the COMAND con-
troller.
X Select the list symbol to the right of the text
message by sliding VY the COMAND con-
troller and press W to confirm.
X Select Delete Delete and press W to confirm.
A deletion prompt appears.
X Select Yes Yes or No No and press W to confirm.
If you select Yes Yes , the text message is
deleted.
If you select
No No , the process will be can-
celed.
i This delete function is not supported by
all mobile phones. The Delete failed Delete failed
message appears.
Using the address book
Introduction
Always pay attention to traffic conditions.
Before starting the journey, familiarize your-
self with the address book functions.
Only use COMAND when the road and traffic
conditions permit. You could otherwise
become involved in an accident in which you
or others could be injured.
The address book organizes and stores
entries that are entered from different sour-
ces (mobile phone, memory card, USB device,
COMAND phone book, navigation system).
You can use these entries to make telephone
calls and for navigation.
i Number of contacts in the address
book: the address book can store a total of
4000 contacts.
1500 entries each are reserved in the
address book for:
R contacts from the mobile phone
R contacts that you create in COMAND or
import from other sources
The remaining 1,000 entries are assigned
by COMAND as necessary.
i Display of mobile phone contacts: con-
tacts downloaded from the mobile phone
remain in the address book even if you dis-
connect the mobile phone from COMAND.
Contacts that have previously been availa-
ble can be displayed as soon as the mobile
phone is reconnected. COMAND down-
loads the contacts again so that any new
contacts that have been added to the
mobile phone can be displayed.
As soon as you connect a new mobile
phone to COMAND all the contacts from
the previous mobile phone are replaced by
those from the new phone's address book.
Address book entries remain stored when
the mobile phone is disconnected. For this
reason, delete your personal data using the
reset function before selling your vehicle,
for example (
Y
page 47).
Calling up the address book
Using the function button:
X Press the % function button.
You see either the telephone basic menu or
the address book, depending on which was
last active.
X
If the telephone basic menu is displayed,
press the % function button again.
Using the address book
147
Tel
eph
one
Z