beautypg.com

Navi gati on, Additional settings – Mercedes-Benz CLS-Class 2014 COMAND Manual User Manual

Page 116

background image

X

To show the menu: press W the COMAND

controller.

X

Select

Navi

Navi

in the main function bar by

sliding ZV and turning cVd the COMAND

controller and press W to confirm.

X

Select

Map

Map Settings

Settings

and press W to con-

firm.

The map settings menu appears.

X

Select

Next Intersecting Street

Next Intersecting Street

and

press W to confirm.

Depending on the previous status, switch

the option on O or off ª.

Traffic information on the map

:

Delimits the section of the route affected

;

Indicates an incident on the route (traffic

flow)

If you subscribe to the SIRIUS XM Satellite

Radio Traffic Message Service, traffic infor-

mation can be displayed on the map. You can

select three categories for the display.

X

To switch the display on/off: press W

the COMAND controller to show the menu.

X

Select

Navi

Navi

in the main function bar by

sliding ZV and turning cVd the COMAND

controller and press W to confirm.

X

Select

Traffic

Traffic Information

Information On

On Map

Map

and

press W to confirm.

X

Select

Incidents

Incidents

and/or

Speed & Flow

Speed & Flow

and/or

Free Flow

Free Flow

and press W to con-

firm.

Depending on the previous status, switch

the option on O or off ª.

Traffic

information

Display on the map

Incidents

Road sections with traffic

incidents are illustrated

with a yellow line and

arrows.

Speed &

Flow

Road sections with traffic

jams are represented by yel-

low or red lines.
Yellow lines: traffic jams,

average speed 25 - 45 mph

(40 - 72 km/h)
Red lines: traffic jams, aver-

age speed 5 - 20 mph

(8 - 32 km/h)

Free Flow

Free flowing road sections

are illustrated with a green

line and arrows.

Additional settings

Avoiding an area

General information

COMAND enables you to avoid areas you do

not wish to drive through.
If you activate or deactivate a route block

while route guidance is active, COMAND will

calculate a new route. If you activate or deac-

tivate a route block while route guidance is

inactive, COMAND will use the new setting for

the next route guidance.

114

Additional settings

Navi

gati

on

This manual is related to the following products: