Navi gati on, Destination input – Mercedes-Benz CLS-Class 2014 COMAND Manual User Manual
Page 74
X
To select a destination: press W the
COMAND controller once or several times.
If COMAND is unable to assign a unique
address, you will see either the address
entry menu with the destination address or
a selection list.
X
Select a destination by turning cVd the
COMAND controller and press W to con-
firm.
If the destination is within the limits of the
digital map, COMAND attempts to assign
the destination to the map.
If the destination can be assigned, you will
see the address entry menu with the
address of the destination. If not, you will
see the
Destination From Map
Destination From Map
entry.
X
To start route calculation: select
Start
Start
and press W to confirm.
Entering a destination using geo-coor-
dinates
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
Destination
in the navigation sys-
tem menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
X
Select
Using Geo-Coordinates
Using Geo-Coordinates
and
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates with the COMAND controller or
the number keypad (
Y
page 36).
X
To change a value: turn cVd the
COMAND controller.
X
To move the mark within the line: slide
XVY the COMAND controller.
X
To move the mark between the lines:
slide ZVÆ the COMAND controller.
X
To confirm the value: press W the
COMAND controller.
i
If the selected position is outside the dig-
ital map, COMAND uses the nearest digi-
tized road for route calculation. You will see
the
The
The coordinates
coordinates are
are outside
outside the
the
map
map area
area
message. If the selected position
is located over a body of water, you will see
the message:
The destination is in
The destination is in
a body of water. Please select
a body of water. Please select
another destination.
another destination.
Entering a destination using
Mercedes-Benz Apps
X
To switch to navigation mode: press the
Ø button.
X
To show the menu: press W the COMAND
controller.
X
Select
Destination
Destination
in the navigation sys-
tem menu bar by turning cVd the
72
Destination input
Navi
gati
on