Kontron CG1200 Carrier Grade Server - Manual (Page 3)

www.kontron.com
www.kontron.com
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide ii
3.2.2 Re-installing the Chassis Cover ............................................................................... 17
3.2.3 Removing the Front Bezel ....................................................................................... 17
3.2.4 Re-Installing the Front Bezel .................................................................................... 18
3.2.5 Removing the Riser Card Assembly......................................................................... 18
3.2.6 Re-Installing the Riser Card Assembly ..................................................................... 19
3.3 Internal System Components Configuration and Installation Procedures ................................. 20
3.3.1 Configuring Memory DIMMs .................................................................................... 20
3.3.2 Supported Memory .................................................................................................. 20
3.3.3 Installing Memory DIMMs ........................................................................................ 21
3.3.4 Replacing or Removing Memory DIMMs .................................................................. 22
3.3.5 Adding or Replacing a Processor ............................................................................. 23
3.3.6 Installing the Heat Sink ............................................................................................ 30
3.3.7 Configuring Jumpers on the Server Board ............................................................... 31
4 Optional Component Installation Procedures ................................. 34
4.1 Before You Begin ................................................................................................................... 34
4.1.1 Tools and Supplies Needed ..................................................................................... 34
4.1.2 System References ................................................................................................. 34
4.1.3 Cable Routing Reference......................................................................................... 34
4.2 Installing or Replacing Hard Disk Drives ................................................................................. 37
4.2.1 Removing an HDD Carrier from the Chassis ............................................................ 37
4.2.2 Installing a Hard Drive in a Carrier ........................................................................... 38
4.3 Installing a Hardware RAID Controller .................................................................................... 40
4.3.1 Installing the ROC Module ....................................................................................... 40
4.3.2 Installing the SuperCap Module ............................................................................... 44
4.4 Adding or Replacing a Power Supply Module ......................................................................... 48
4.4.1 Adding a Second Power Supply Module .................................................................. 48
4.4.2 Replacing a Power Supply ....................................................................................... 49
4.5 Replacing a PCI Riser Card .................................................................................................... 49
4.5.1 Removing the Old Riser Card .................................................................................. 50
4.5.2 Installing a new Riser Card ...................................................................................... 50
4.6 Installing a PCI Add-in Card ................................................................................................... 50
4.7 Installing a Remote Management Module 4 ............................................................................ 52
4.8 Installing an I/O Module .......................................................................................................... 56
4.9 Installing an eUSB Flash Drive ............................................................................................... 58
4.10 Installing the Server into a Rack ............................................................................................. 59
4.10.1 Connecting the Power Cord ............................................................................... 59