Kontron CG1200 Carrier Grade Server - Manual (Page 25)

19
Kontron CG1200 Carrier Grade Server Installation and Maintenance Guide 19
2. Remove the chassis cover. For instructions, see Section 3.2.1 “Removing the Chassis Cover”.
3. Loosen the blue captive retention screw (
4. Figure 11, “A”) at the front of the riser assembly and the blue captive screw at the back panel of the
chassis.
5. Unhook the rear of the assembly from the guide pin on the back panel and lift the riser card assembly
out of the chassis.
Figure 11: Removing the Riser Card Assembly
3.2.6 Re-Installing the Riser Card Assembly
To re-install the riser card assembly:
1. Align the riser card with the card slot on the server board.
2. Position the riser front tab/captive screw over the stand-off on the chassis floor.
Make sure the tab at the rear of the assembly hooks over the guide pin on the chassis back panel.