Elecraft XV Assembly Manual for XV432 MHz - Manual (Page 41)

- 39 -
RED WIRE PASSES THROUGH HOLE IN CIRCUIT VIA TO
BOTTOM SIDE OF BOARD. PULL THE EXCESS WIRE
THROUGH THE HOLE.
BLACK WIRE SOLDERED TO PAD B.
Figure 37. Installing Fan.
On the bottom of the board, route the lead to the solder pad at relay
K5 as shown in Figure 38. Cut and strip the lead, and solder it to the relay
pin. The relay pin provides an easy attachment point since there is no
solder pad for this lead.
CORNER PIN OF K5 THAT CONNECTS TO
CATHODE OF DIODE D15.
RED FAN WIRE FROM TOP OF PCB
Figure 38. Fan Wire Routing on Bottom of PCB.
Locate the bottom cover of your transverter. This is the plate with
two sets of cooling air holes.
Inspect the inside surface of the cover. Remove any masking tape
you find.
If you purchased the optional feet and bail for your transverter,
install them on the bottom cover now.