Elecraft XV Assembly Manual for XV432 MHz - Manual (Page 11)

- 9 -
Parts Inventory
You should do a complete inventory. Contact Elecraft if you find anything missing.
i
Leave painted panels wrapped until they are needed during assembly. This will protect the finish.
Cabinet and RF PCB components
Picture Ref. Designator(s) QTY Description Part #
1
RF Printed Circuit Board, XV432
i
Handle with care – ESD Sensitive. This PCB is supplied with a
number of surface-mount devices (SMD) pre-mounted. Some of these
components are static sensitive and vulnerable until other parts are installed
on the PCB. There are temporary jumpers across the solder pads for L1 and
R13 to prevent static damage to Q3. Do not remove these jumpers until
instructed to do so. Take ESD precautions (see page 5) when handling.
E850218
1 Front Panel E100153
1 Rear Panel E100154
XV432 1 Front Panel Label, XV432 E980062
See Figure 1
2 Side Panel E100140
1 Top Cover E100267
1 Bottom Cover E100268
1 Heat Spreader E100156
8 2-D Fastener E100078
2 Right Angle Bracket E700073
40 Pan Head Black Machine Screw, 3/16 inch. 4-40. E700015
5 Pan Head Zinc or Stainless Machine Screw, 5/16 inch, 4-40 E700077
2 Pan Head Black Machine Screw, 1/2 inch, 4-40 E700030
4 Pan Head Black Machine Screw, 5/8 inch, 4-40 E700114