Dynojet 424xLC2: Installation Guide - Manual (Page 76)

C H A P T E R 3
Bridge Installation—Stationary Dyno
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-34
BRIDGE INSTALLATION—STATIONARY DYNO
Use the following instructions to install the drum guards, runner mounts and
supports, runner assemblies, and the bridge cover.
You will need the following parts:
• 21214703 Runner Clamp Plate (2)
• 21214704 Runner Slide (2)
• 21216101 Drum Guard, Right
• 21216102 Drum Guard, Left
• 21216103 Drum Guard (2)
• 21219511 Stationary Cover
• 21514802 Runner Mount (z-shaped) (2)
• 36562070 Bolt, 1/4-20 x 1.25", Hex (16)
• 36580434 Bolt, 3/8-16 x 1/2", Button-Head, Flange, Allen (4)
• 36582034 Bolt, 3/8-16 x 1.25", Button-Head, Flange, Allen (8)
• 36582471 Bolt, 3/8-16 x 1.5", Flange-Hex (6)
• 36588071 Bolt, 3/8-16 x 5", Black Oxide (16)
• 36701100 Nut, 1/2-13, Hex (8)
• 36800000 Bolt, 1/2-13 3", Hex (8)
• 36912100 Washer, 1/4", Splitlock, Steel (16)
• 36923100 Washer, 3/8", Hardened, Flat, Steel (24)
• 36932100 Washer, 3/8", Splitlock, Steel (24)
• 36942100 Washer, 1/2", Splitlock, Steel (8)
• 37513200 Anchor, Redhead, 3/8" (4)
• 37518200 Redhead Anchor Installation Tool
• 61314500 Runner Support Assembly (4)
• 61319500 Runner Assembly (30)
• DM150-011-004 Nut, 3/8-16, Hex (16)
• DM150-011-006 Bolt, 3/8-16 x 1.25", Hex (8)