Dynojet 424xLC2: Installation Guide - Manual (Page 181)

E-3
I N T E R F A C E R O L L E R A S S E M B L Y I N S T A L L A T I O N
Interface Roller Assembly Installation
Version 1 Above Ground Model 424c/424xLC
2
Automotive Dynamometer Installation Guide
3 Align the rollers on the interface roller assembly with the interface tube on the
dyno.
Note: The distance between the dyno and the lift may need to be adjusted.
4 Using the 1/2-inch and the 1/4-inch thick shims as necessary, adjust the interface
roller assembly to fit the lift cross member.
5 Lower the lift until the interface roller assembly just starts to enter the interface
tube.
6 Tighten the hardware securing the interface roller assembly to the lift cross
member.
Note: The interface roller assembly mounting bolts should touch the bottom of
the lift cross member.
7 Raise and lower the lift several times to make sure that the interface roller
assembly is working smoothly. Adjust the interface roller assembly if needed.
8 Verify the lift can be lowered down to floor level.
Figure E-2: Align the Interface Tube and the Interface Roller Assembly
SA018
interface tube
interface roller assembly
shim
mounting bolt
lift cross member