Dynojet 424xLC2: Installation Guide - Manual (Page 44)

C H A P T E R 3
Unpacking and Inspecting the Dyno
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
3-2
UNPACKING AND INSPECTING THE DYNO
When you receive your dyno, examine the exterior of the shipping container for any
visible damage. If damage is detected at this stage, contact the shipper or Dynojet
before proceeding with unpacking.
Use the following steps to unload your dyno. You will need to provide equipment
capable of lifting a minimum of 2,495 kg (5,500 lb.) to move the crated dyno into
position in your dyno room. Refer to “Dynamometer Specifications and
Requirements” on page 1-4 for more information.
1 Move the crated dyno (crate 2) to a clear area near your dyno room.
2 Using a pry bar, or a large flat screwdriver, and a hammer, carefully remove the
top and sides of the crate.
Note: At this point, you will want to inspect the exterior of the dyno for any
indications of damage. Report any damage immediately.
3 Remove the following parts from the crate and set aside.
Note: Some of these parts may have been shipped in the stationary dyno crate
(crate 1).
4 Verify the contents of the hardware boxes and set aside.
Note: The hardware required for the 4WD dyno installation may be packed in the
stationary dyno crate (crate 1).
part description part description
bridge cover, stationary
dyno
P/N 21219511
anchor, redhead, 3/8" (12)
P/N 37513200
bridge cover, 4WD dyno
P/N 21219512
installation tool, redhead
anchor
P/N 37518200
rail (2)
P/N 21514282
cylinder mount, dyno
P/N 61300016
rail tie (3)
P/N 21716400
cylinder mount, floor
P/N 61300061