Dynojet 424xLC2: Installation Guide - Manual (Page 35)

2-9
S T A T I O N A R Y D Y N O I N S T A L L A T I O N
Dyno Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
P LACING THE D YNO IN F RONT OF THE L IFT
1 Verify the interface bracket faces the lift as shown in Figure 2-3.
2 Verify the lift is in the down position.
3 Using the forklift, bring the dyno in front of the lift. The dyno should be about
10.16 cm (4.00 in.) from the lift cross member.
4 Center the dyno drum with the lift runways.
5 Gently lower the dyno into position.
Figure 2-3: Dyno with Lift
lift runway
lift runway
cross member
interface bracket
10.16 cm
(4.00 in.)