Dynojet 424xLC2: Installation Guide - Manual (Page 38)

C H A P T E R 2
Dyno Installation
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
2-12
5 Verify the interface guide clears the interface bracket by 1/8-inch to 1/4-inch as
shown in Figure 2-6.
6 Slide the interface guide up until the bottom bolt touches the cross member.
Lower the top bolt down in the slots until it touches the cross member.
7 Tighten the hardware securing the interface guide to the lift cross member.
Note: The lower and upper interface guide mounting bolts should touch the lift
cross member.
8 Raise and lower the lift several times to make sure that the interface guide is
working smoothly. Adjust the interface guide if needed.
9 Verify the lift can be lowered down to floor level.
Figure 2-6: Verify Distance Between Interface Guide and Interface Bracket
interface guide on
cross member
interface bracket
on dyno
0.125" to .250"