Dynojet 424xLC2: Installation Guide - Manual (Page 171)

C-17
S T A T I O N A R Y D Y N O U P G R A D E
Air Fittings Upgrade
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
AIR FITTINGS UPGRADE
Before the stationary dyno can be used with the 4WD dyno, the existing air fittings on
the stationary dyno must be upgraded.
You will need the following parts:
• 3400X4 Fitting, Street Tee
• 141900001 Fitting, Barbed Hose
• 34122231
Bushing, 1/4"F x 3/8"M, Brass
• 34161320 Elbow-90, 3/8"H x 1/4"P
1 Remove the existing air inlet fitting from the brake solenoid assembly.
2 Install the street tee.
3 Replace the air inlet fitting removed earlier.
4 Install a barbed hose fitting into the street tee.
5 Remove the existing plug from the air can.
6 Install one 3/8-1/4-inch bushing and elbow fitting.
7 Continue with installing the 4WD dyno in Chapter 3.
Figure C-16: Upgrade the Air Fittings
A 560 D
existing air inlet fitting
brake solenoid
assembly
street tee
barbed hose fitting
bushing and
elbow fitting