Dynojet 424xLC2: Installation Guide - Manual (Page 14)

C H A P T E R 1
Dynamometer Specifications and Requirements
Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
1-4
DYNAMOMETER SPECIFICATIONS AND REQUIREMENTS
The following specifications and requirements will help you set up your dyno area and
verify you have the requirements necessary to operate your dyno safely.
C HASSIS S PECIFICATIONS
description specifications
Length
of frame 218.44 cm (86.00 in.)
of frame with eddy current brake 321.23 cm (126.47 in.)
Height
to top of frame 58.42 cm (23.00 in.)
to top of frame with feet/track
assembly 72.07 cm (28.375 in.)
Width
of frame 73.66 cm (29.00 in.)
including cradle assembly 130.18 cm (51.25 in.)
including air brake 93.83 cm (36.94 in.)
both frames, deck, bridge—full in 397.00 cm (156.30 in.)
both frames, deck, bridge—full in
with extension kit 422.40 cm (166.30 in.)
both frames, deck, bridge—full out 487.68 cm (192.00 in.)
both frames, deck, bridge—full out
with extension kit 513.08 cm (202.00 in.)
Track Assembly
Length 208.92 cm (82.25 in.)
Width 218.44 cm (86.00 in.)
Weight
stationary crated dyno 2,114 kg (4,660 lb.)
4WD crated dyno 2,495 kg (5,500 lb.)
Drum
diameter 60.96 cm (24.00 in.)
width 205.74 cm (81.00 in.)
Frame structural steel channel and angle
Maximum Speed 322 kph (200 mph)
Maximum Axle Weight 1361 kg (3000 lb.)
Remote Switches remote software control