Dynojet 424xLC2: Installation Guide - Manual (Page 39)

2-13
S T A T I O N A R Y D Y N O I N S T A L L A T I O N
Dyno Installation
Version 1 Above Ground Model 424x/424xLC
2
Automotive Dynamometer Installation Guide
A NCHORING THE D YNO
Dynojet recommends you secure your dyno to the floor in your dyno room using
concrete anchors. Use the following instructions to secure the dyno to the floor.
You will need the following parts:
• 36923100 Washer, 3/8", Hardened, Flat, Steel (4)
• 37513200 Anchor, Redhead, 3/8" (4)
• 37518200 Redhead Anchor Installation Tool
• DM150-019-012 Bolt, 3/8-16 x 1", Hex (4)
1 Using the mounting feet as a template, mark and drill each hole needed to secure
the four dyno feet to the floor.
2 Install four Red Head anchors. Refer to Appendix A for installation instructions.
3 Secure each mounting foot to the floor using one 3/8-16 x 1-inch hex-head bolt
and one 3/8-inch flat washer.
Figure 2-7: Secure the Dyno to the Floor
A 514 D
secure dyno
to floor
secure dyno to
floor
lift