Canon EOS 300 D - Manual (Page 65)

Drive Mode Selection
The drive mode can be set to single or continuous (2.5 frames per
sec.).
Press the < Qj
• < S ) ] >
button. (
^
6
)
► The button toggles between the two
drive modes.
© The continuous drive mode can be
selected in the Creative Zone modes.
□ : Single
Qj: Continuous
cv)f : Self-timer/Remote control
O
During continuous shooting, the captured images are first stored in the
camera's internal memory and then successively transferred to the CF
card. When the internal memory becomes full during continuous
shooting, “fauSy” will be displayed on the LCD panel and in the
viewfinder and the camera cannot take any more shots.
As the captured images are transferred to the CF card, you will be able
to capture more images. Press the shutter button halfway to check in the
viewfinder the current remaining number of maximum burst ('-i to 0) for
continuous shooting. The maximum burst number will not be displayed
when there is no CF card in the camera.
If you press the shutter button halfway before all the images in the
internal memory are transferred to the CF card (while the access lamp
blinks), the image transfer to the CF card will stop temporarily.
If “FuLL CF” is displayed in the viewfinder and on the LCD panel, wait
until the access lamp turns off, then replace the CF card.
© The number display “*-i” - “!j” to the left of the focus confirmation light
<•> indicates the maximum number of continuous shots (maximum
burst) that can be taken.
© With white balance bracketing (p.53), the four shots can be taken
continuously.
65