Recharging the battery, Connect the power cord, Remove the cover – Canon EOS 300 D User Manual
Page 18: Attach the battery, Recharge the battery
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recharging the Battery
Connect the power cord.
@ Connect the power cord to the charger.
© Connect the power plug to an AC
outlet.
Remove the cover.
o If you remove the battery from the
camera, be sure to reattach the cover
to protect against short circuit.
Attach the battery.
@ Align the battery’s top edge with the
<—> mark on the charger. While
pressing down the battery, slide it in
the direction of the arrow.
• To detach the battery, follow the above
procedure in reverse.
Recharge the battery.
► When the battery is attached to the
charger, recharging starts
automatically and the red lamp starts
blinking.
k
A completely exhausted battery
takes about 90 minutes to almost
fully recharge.
Recharge Level
Red lamp
0-50%
Blinks once per second
50-75%
Blinks twice per second
75-90%
Blinks three times per
second
90% or higher
Stays on
The numbers around red lamp and the
blinking frequency correspond to the table
above.
18