Dell PowerEdge RAID Controller 6i - Manual (Page 109)

Configuring and Managing RAID
109
After you enable the BIOS for a controller, perform the following steps to enable
the boot support for that controller.
1 Press to access the Ctrl Mgmt menu screen.
2 Press to move the cursor to the Select Bootable VD in the
Settings box.
3 Press the down arrow key to display a list of virtual disks.
4 Use the down arrow key to highlight a virtual disk.
5 Press to select the virtual disk.
6 Press to move the cursor to the Apply button, and then press
to apply the selection.
Boot support is enabled for the selected controller.
Enabling BIOS Stop on Error
The option BIOS Stop on Error is used to stop the system from booting if
there are BIOS errors. Perform the following steps to enable BIOS Stop on
Error.
1 Press to access the Ctrl Mgmt menu screen.
2 Press to move the cursor to Enable BIOS Stop on Error in the
Settings box.
3 Press the spacebar to select Enable BIOS Stop on Error.
An X displays beside Enable BIOS Stop on Error.
4 Press to move the cursor to the Apply button, and then press
to apply the selection.
The controller BIOS is enabled. To disable Enable BIOS Stop on Error,
use the spacebar to deselect Enable BIOS Stop on Error, then select
Apply and press .
Dell_PERC6.1_UG.book Page 109 Wednesday, April 15, 2009 4:18 PM