Dell Precision 670 - Manual (Page 70)

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
appropriate SCSI ID number.
NOTICE: Dell recommends that you use only SCSI cables purchased from Dell. Cables purchased elsewhere are not
guaranteed to work with Dell computers.
Device Termination
SCSI logic requires that termination be enabled for the two devices at opposite ends of the SCSI chain and disabled for all
devices in between.
It is recommended that you use terminated cables and that you disable termination on all devices. See the documentation
provided with any optional SCSI device you purchase for information on disabling termination on the device.
General Guidelines
Follow these general guidelines when installing SCSI devices in your computer:
Although you install SCSI devices essentially the same way as other devices, their configuration requirements are
different. For details on configuring your particular SCSI subsystem, see the documentation for your SCSI devices
and/or your host adapter card.
Configure the device for a SCSI ID number and disable termination, if necessary.
To use an external SCSI device, you must have a SCSI controller card installed in your computer. Connect one end of
the external SCSI cable to the connector on the back of the SCSI device. Attach the other end of the external SCSI
cable to the connector on the controller card installed in the computer.
After you install a SCSI hard drive, Primary Drive 0 and Primary Drive 1 should be set to None in system setup if
no IDE hard drives are installed. If you have any IDE devices on the second IDE channel, such as a CD or tape drive,
Secondary Drive 0 and/or Secondary Drive 1 should be set to Auto.
To partition and format SCSI hard drives, you may need to use programs other than those provided with the operating
system. See the documentation that came with your SCSI software drivers for information on installing the appropriate
drivers and preparing your SCSI hard drive for use.
SCSI Cables
Ultra 320, Ultra 160/m, and Ultra2/Wide LVD drives (typically hard drives) both use a 68-pin cable. One end of the cable
attaches to the SCSI connector on the system board or the SCSI controller card installed in your computer. The remaining
connectors on the cable attach to the various drives.
Narrow SCSI drives (tape drives, CD drives, and some hard drives) use a 50-pin cable. One end of this cable attaches to the
SCSI controller card. The remaining connectors on the cable attach to the various Narrow SCSI devices.
NOTICE: Dell recommends that you use only SCSI cables purchased from Dell. Cables purchased elsewhere are not
guaranteed to work with Dell computers.
Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a
foam pad, that will sufficiently cushion it.
1. If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this
procedure.
2. Follow the procedures in " Removing and Replacing Parts ."