Dell Precision 670 - Manual (Page 104)

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
1 filler bracket
2 alignment bar
3 alignment guide
4 retention arm
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer
cover from closing properly or cause damage to the equipment.
11. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
12. Close the computer cover , reconnect the computer and devices to electrical outlets, and then turn them on.
13. If you installed a sound card:
a. Enter system setup , select Integrated Devices, and then change the setting for Sound to Off.
b. Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the
microphone, speaker/headphone, or line-in connectors on the back panel.
14. If you installed an add-in network adapter:
a. Enter system setup , select Integrated Devices, and then change the setting for Network Interface Card to
Off.
b. Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the
integrated connector on the back panel.
15. Install any drivers required for the card as described in the card documentation.
Removing a PCI Express Card