Dell Precision 670 - Manual (Page 67)

Removing and Replacing Parts: Dell Precision Workstation 470 and 670 Computers User's Guide
file:///T|/htdocs/systems/ws670/EN/ug_en/before.htm[3/20/2013 9:31:52 AM]
Memory Fan and Shroud
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
NOTICE: If you install more than 4 GB of memory, you must also install a fan to cool the computer. If you do not
install a fan, you will get an error message stating that you must install a fan or remove some memory.
Installing the Memory Fan and Shroud
1. Follow the procedures in " Removing and Replacing Parts ."
2. Align the tabs on the back of the shroud with the back of computer.
3. Insert the tabs and lower the shroud in place over the memory modules.
4. Connect the fan cable to the memory fan connector labeled "FAN_MEM" on the system board (for your Dell Precision
670, see " System Board Components " and for your Dell Precision 470 computer, see " System Board Components ").
Drives for the Dell Precision 670 Computer
Overview
Your computer supports:
Three hard drives (Serial ATA and SCSI)
One floppy drive (optional)
Three CD or DVD drives (One bay may be used for an additional hard drive using an add-in bay bracket.)