Power problems – Dell Precision 670 User Manual
Page 159
Solving Problems: Dell Precision Workstation 470 and 670 Computers User's Guide
file:///T|/htdocs/systems/ws670/EN/ug_en/solve.htm[3/20/2013 9:31:58 AM]
Check the network lights on the back of the computer —
No light indicates that no network
communication exists. Replace the network cable.
Restart the computer and log on to the network again
Check your network settings —
Contact your network administrator or the person who set up your network
to verify that your network settings are correct and that the network is functioning.
Check for software and hardware compatibilities
Power Problems
Fill out the
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
If the power light is green and the computer is not responding —
See "
If the power light is blinking green —
The computer is in standby mode. Press a key on the keyboard or
move the mouse to resume normal operation.
If the power light is off —
The computer is either turned off or is not receiving power.
Reseat the power cable into both the power connector on the back of the computer and the electrical
outlet.
If the computer is plugged into a power strip, ensure that the power strip is plugged into an electrical
outlet and that the power strip is turned on. Also bypass power protection devices, power strips, and
power extension cables to verify that the computer turns on properly.
Ensure that the electrical outlet is working by testing it with another device, such as a lamp.
Ensure that the main power cable and front panel cable are securely connected to the system board (for
the Dell Precision 670 computer, see "
" and for the Dell Precision 470
computer, see "
If the power light is amber and green or steady amber —
A device might be malfunctioning or
incorrectly installed.
Remove and then reinstall the memory modules.
Remove and then reinstall any cards.
Remove and then reinstall the graphics card, if applicable.
If the power light is blinking amber —
The computer is receiving electrical power, but an internal power
problem might exist.
Ensure that the voltage selection switch is set to match the AC power at your location (if applicable).
Ensure that the processor power cable is securely connected to the system board (for the Dell Precision
670 computer, see "
" and for the Dell Precision 470 computer, see "
Eliminate interference —
Some possible causes of interference are:
Power, keyboard, and mouse extension cables
Too many devices on a power strip
Multiple power strips connected to the same electrical outlet