Dell PowerEdge M520 (for PE VRTX) - Manual (Page 17)

Menu Item Description
NOTE: This option is displayed only if IDSDM is installed on the system board.
Integrated Network
Card 1 Allows you to enable or disable the integrated network card 1. By default, the Integrated
Network Card 1 option is set to Enabled.
OS Watchdog Timer Allows you to enable or disable the OS watchdog timer. When this field is enabled, the
operating system initializes the timer and the OS watchdog timer helps in recovering the
operating system. By default, the OS Watchdog Timer option is set to Disabled.
Embedded Video
Controller Allows you to enable or disable the Embedded Video Controller. By default, the embedded
video controller is Enabled.
SR-IOV Global Enable Allows you to enable or disable the BIOS configuration of Single Root I/O Virtualization (SR-
IOV) devices. By default, the SR-IOV Global Enable option is set to Disabled.
Mezzanine Slot
Disablement Allows you to enable or disable available PCIe mezzanine card slots on your system. The Slot
Disablement feature controls the configuration of PCIe mezzanine cards installed in the
specified slot.
CAUTION: Slot disablement must be used only when the installed peripheral card is
preventing booting into the Operating System or causing delays in system startup. If the
slot is disabled, both the Option ROM and UEFI driver are disabled.
NOTE: Use this option only for troubleshooting purposes. If one or more of the PCIe
mezzanine card slots are disabled, an error message is displayed during system startup.
For proper operation, make sure that the server module has two Dell PCIe mezzanine
cards installed and both cards are set to Enabled.
NOTE: The Boot Driver Disabled option does not apply to the M520 when operating in the
PowerEdge VRTX chassis. Selecting this option will have the same result as selecting
Enabled.
Serial Communications Screen
Menu Item Description
Serial Communication Allows you to enable the COM port or Console Redirection options.
Serial Port Address Allows you to set the port address for serial devices. By default, the Serial Port Address option
is set to COM1.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use console
redirection by SOL, configure the same port address for console redirection and the serial
device.
Failsafe Baud Rate Displays the failsafe baud rate for console redirection. The BIOS attempts to determine the
baud rate automatically. This failsafe baud rate is used only if the attempt fails and the value
must not be changed. By default, the Failsafe Baud Rate option is set to 11520.
Remote Terminal
Type Allows you to set the remote console terminal type. By default, the Remote Terminal Type
option is set to VT 100/VT220.
17