Dell OptiPlex G1 User Manual
Page 98
ISA Configuration Utility Messages: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/isa.htm[2/21/2013 11:53:05 AM]
category card. Press OK to
proceed.
chosen is not the
correct category under
which to add this card.
the correct category's dialog box.
Continue the procedure for adding the
card as described in "
" or "
No more DMA values can be
added.
No more interrupt values
can be added.
No more memory values can
be added.
No more I/O port values can
be added.
No more values are
available for the
resource you are trying
to add or modify.
The maximum number of values for each
resource is as follows:
4 DMA channels
7 IRQ lines
9 memory address blocks
20 I/O ports
To free values for the resource you are
trying to add or modify, delete some of
the values listed in the resource box for
the card. If your card requires all of the
values listed, contact your card
manufacturer to resolve the issue.
The ICU detects a resource
conflict between this card
and conflicting_card. The
conflicting resource was:
resource.
You added or modified
a card that now
requires a
resource
value already in use by
conflicting_card.
Try each of the following options until the
problem is resolved:
Modify the card you are adding so
that it uses a different value for
resource. See "
for instructions.
Modify conflicting_card so
that it uses a different value for
resource. See "
for instructions.
If conflicting_card is not the
system board, remove it from the
computer. See "
"
for instructions.
Remove all expansion cards from
the ICU, and then add them back
one at a time, beginning with the
new card and resolving resource
conflicts as they arise. See
"
" and "
" or "
" for instructions.
If you cannot resolve the resource
conflict by any of the preceding
methods, remove the new card. If
you were modifying an existing
card, reset the modified card to its
previous resource value.
The configuration (.cfg)
This message appears
Use the following procedure: