Dell OptiPlex G1 - Manual (Page 101)

ISA Configuration Utility Messages: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/isa.htm[2/21/2013 11:53:05 AM]
Manager for it to run.
ERROR: Fatal BIOS error
Internal Error Code. A BIOS call failed with
an internal error. The
most likely cause is an
incompatibility
between the BIOS
and the Configuration
Manager. See " Getting Help " in your Diagnostics and
Troubleshooting Guide for instructions on
obtaining technical assistance.
ERROR: Could not read NVS,
Error=Internal Error Code. An attempt to read the
NVRAM failed. See " Getting Help " in your Diagnostics and
Troubleshooting Guide for instructions.
ERROR: Failed NVS write.
Error=Internal Error Code. An attempt to write to
NVRAM failed. Run the Dell Diagnostics to verify the
integrity of your system NVRAM. See
"Running the Dell Diagnostics" in your
Diagnostics and Troubleshooting Guide for
instructions.
If you are unable to determine the cause of
the error, see "
Getting Help " in your
Diagnostics and Troubleshooting Guide for
instructions.
ERROR: Failed to activate
device, CSN=Card Select
Number. A Plug and Play
expansion card could
not be activated. Use the following procedure:
1. Exit the ICU and turn off your system.
2. Remove the Plug and Play expansion
card that could not be activated.
Follow steps 2 through 6 of
"
Removing an Expansion Card " and
then return to this procedure.
3. Reinstall the Plug and Play expansion
card.
Follow steps 5 through 10 of
"
Installing an Expansion Card " and
then return to this procedure.
If you still receive the error message,
contact the manufacturer of the Plug and
Play expansion card for assistance.
WARNING: Could not
configure Plug and Play
Card Name.
WARNING: Could not
The card(s)
mentioned are not
fully configured due to
resource conflicts. If you have documentation that lists the
allowable resource values for your Plug
and Play or PCI expansion card, you can
use the following procedure to locate and
resolve the resource conflict.