Dell OptiPlex G1 User Manual
Page 27
Using the System Setup Program: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/system.htm[2/21/2013 11:52:58 AM]
you can type numbers in both fields.
The default for Auto Power On is Disabled.
Power Management
For certain types of monitors and most EIDE hard-disk drives, you can reduce system power consumption by
enabling the power management feature. With Power Management enabled, these monitors and drives
automatically switch into low-power mode during periods of system inactivity.
Power Management can be implemented at three levels—Maximum, Regular, and Minimum. (The different
levels apply to the monitor only; hard-disk drive operation is the same for all three.) The default for this
option is Disabled.
Saving Monitor Power
If you have a Video Electronics Standards Association (VESA®) Display Power Management Signaling
(DPMS)-compliant monitor, enabling the Power Management option reduces monitor power consumption
during periods of keyboard and mouse inactivity
NOTICE: Check your monitor documentation to make sure you have a DPMS-compliant monitor
before you enable this feature. Otherwise, you risk damaging the monitor.
NOTE: The power management feature monitors activity of a mouse connected to the Personal
System/2 (PS/2)-compatible mouse port.
By setting Power Management to Maximum, Regular, or Minimum, you can set predefined time-out periods
(see
) for the two successive monitor shutdown stages, standby and off.
NOTE: Each monitor manufacturer defines the details of the shutdown stages for its own monitors.
But in all cases, power consumption decreases with each stage from "on" (full power) to "standby"
(reduced power; the display image usually disappears) to "off" (where power consumption is minimal).
To define these stages for your monitor, see the documentation that came with the monitor.
From either shutdown stage, you can return full power to the monitor in one of the following ways:
For most DPMS-compliant monitors, any subsequent activity—including moving the mouse—should
return full power to the monitor.
A few DPMS-compliant monitors require that you turn monitor power off and then on again to return to
full power.
Check your monitor documentation for information on how your monitor is designed to operate.
Saving EIDE Hard-Disk Drive Power
For most systems, enabling Power Management at any level causes EIDE hard-disk drives to switch to low-
power mode after about 20 minutes of system inactivity (see
NOTES: All EIDE drives shipped with your system support this feature. (For more information on