beautypg.com

Configuration manager messages – Dell OptiPlex G1 User Manual

Page 100

background image

ISA Configuration Utility Messages: Dell OptiPlex GX1 Low-Profile Managed PC Systems

file:///C|/infodev/2013/eDoc/OpGX1/SQRG/isa.htm[2/21/2013 11:53:05 AM]

values different
from the card's
defaults.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online
System User's Guide.

Configuration Manager Messages

The Configuration Manager for the ICU identifies problems following system boot and generates messages if
necessary. These messages alert you to any unsuccessful attempts to configure Plug and Play or Peripheral
Component Interconnect (PCI) expansion cards, as well as any problems that interfere with the operation of
the Configuration Manager. If you receive a message from the Configuration Manager, see the following
table for suggestions on resolving problems indicated by the message.

Message

Probable Cause

Corrective Action

Found Plug and Play ISA
card: Plug and Play ISA
Card Name
.

This message
appears at system
start-up for each Plug
and Play ISA
expansion card
recognized by the
Configuration
Manager.

Status message; no action is required.

NOTICE: Boot Device Not
Active! CSN=Card Select
Number
.

A boot device was
found to be inactive.

Status message; no action is required. The
Configuration Manager automatically
configures and activates the device.

One or more active devices
have been reconfigured -
system requires reboot.
Press any key to reboot
system.

You modified the
resource values of
one or more PCI or
Plug and Play ISA
expansion cards.

Reboot the system to reconfigure the
card(s).

The Plug and Play ISA card
has been successfully
configured.

Card Count Plug and Play
ISA cards have been
successfully configured.

The Configuration
Manager has
successfully
configured the given
number of cards.

If this message does not match the number
of Plug and Play ISA expansion cards
installed in your computer, reinstall any
Plug and Play expansion cards not listed
and reboot the system.

ERROR: Insufficient CM
Memory

There is not enough
memory available to
the Configuration

Disable any TSR programs or any
unneeded device drivers.