Dell OptiPlex G1 - Manual (Page 60)

Working Inside Your Computer: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/computer.htm[2/21/2013 11:53:01 AM]
Replacing the Expansion-Card Cage
Use the following procedure to replace the expansion-card cage:
1. With the securing lever in the upright position, align the slots in the left side of the expansion-card cage
with the tabs on the left side of the chassis (see Figure 7 ).
2. Rotate the securing lever downward until it is flush with the top of the chassis. Make sure that the riser
board is fully seated in the RISER connector on the system board.
3. Reconnect any cables you removed in step 2 of " Removing the Expansion-Card Cage ."
4. Replace the computer cover , and reconnect your computer and peripherals to their electrical outlets
and turn them on.
NOTE: If Enabled, the Chassis Intrusion option will cause the following message to be displayed
at the next system start-up:
ALERT! Cover was previously removed.
Back to Contents Page