Dell OptiPlex G1 User Manual
Page 73
Installing System Board Options: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/options.htm[2/21/2013 11:53:02 AM]
screwdriver.
5. Install the new battery.
Orient the battery with the side labeled "+" facing up (see Figure 11). Then insert the battery into the
socket, and snap it into place.
Figure 11. System Battery and Battery Socket
6. Replace the expansion-card cage as described in "
Replacing the Expansion-Card Cage
7.
, and reconnect your computer and peripherals to their electrical outlets
and turn them on.
NOTE: If Enabled, the
option will cause the following message to be displayed
at the next system start-up:
ALERT! Cover was previously removed.
8. Enter the
and confirm that the battery is operating properly.
9. Enter the correct time and date through the System Setup program's Time and Date categories. Also,
use the copy you made in step 1 to restore the correct settings for other system configuration
information. Then exit the System Setup program.
10. Turn off your computer, and unplug it for at least 10 minutes.
11. After 10 minutes, plug in the computer, turn it on, and enter the System Setup program. If the time and
date are still incorrect, see the chapter titled "Getting Help" in your Diagnostics and Troubleshooting
Guide for instructions on obtaining technical assistance.