Dell OptiPlex G1 User Manual
Page 64
Installing System Board Options: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/options.htm[2/21/2013 11:53:02 AM]
6. When the card is firmly seated in the connector and the card-mounting bracket is flush with the
brackets on either side of it, secure the bracket with the screw you removed in step 4.
7. If you are installing an optional Wakeup On LAN network card, attach the three-wire power cable that
came with the card to the P1 connector on the riser board (see
) and to the network interface
controller (NIC) card.
8. Replace the expansion-card cage in the chassis as instructed in "
."
9. Connect any cables that should be attached to the card.
See the documentation that came with the card for information about its cable connections.
10.
, and reconnect your computer and peripherals to their electrical outlets
and turn them on.
NOTE: If Enabled, the
option will cause the following message to be displayed
at the next system start-up:
ALERT! Cover was previously removed.
Removing an Expansion Card
CAUTION: To avoid the possibility of electric shock, turn off the computer and any peripherals,
disconnect them from their electrical outlets, and then wait at least 5 seconds before you
remove the computer cover. Also, before you install an expansion card, see "
."
Follow this procedure to remove an expansion card:
1. If you are removing a non-Plug and Play ISA expansion card, enter the ICU and remove the expansion
card from your configuration.
See "
Using the ISA Configuration Utility
" for instructions.
2. Remove the computer cover according to the instructions in "
3. If necessary, disconnect any cables connected to the card.
4. Remove the expansion-card cage as instructed in "
Removing the Expansion-Card Cage
."