Dell OptiPlex G1 User Manual
Page 102
ISA Configuration Utility Messages: Dell OptiPlex GX1 Low-Profile Managed PC Systems
file:///C|/infodev/2013/eDoc/OpGX1/SQRG/isa.htm[2/21/2013 11:53:05 AM]
configure PCI device,
ID=DeviceID.
Failed to configure Number
of Total Count Plug and
Play ISA devices. Use your
system's configuration
utility to resolve
conflicts. Press any key to
continue.
NOTE: If you do not have documentation
listing the allowable resource values, see
the corrective action for these messages in
the next table entry.
1. Start the ICU.
Any Plug and Play or PCI expansion
cards that could not be configured
should be marked with config err
on the list of cards in the ICU window.
2. Select the System Resources option
from the View menu.
The System Resource Usage dialog
box displays all resources currently
used by the system.
3. Select one of the resources used by
your Plug and Play or PCI expansion
card, and click Used By Card.
The Card Resources Usage dialog
box identifies which device is using
the resource.
4. Repeat step 3 until you have
identified all conflicting resources and
the cards that use them.
5. Modify the cards, as needed, to free
the resources required by the
unconfigured Plug and Play or PCI
expansion card.
See "
" for
instructions.
WARNING: Could not
configure Plug and Play
Card Name.
WARNING: Could not
configure PCI device,
ID=DeviceID.
Failed to configure Number
of Total Count Plug and
The card(s)
mentioned are not
fully configured due to
resource conflicts.
If you do not know the allowable resource
values for your Plug and Play or PCI
expansion card, use the following
procedure to locate and resolve the
resource conflict:
1. Remove all card configurations from
the ICU.
See "
" for
instructions.