beautypg.com

Dell OptiPlex G1 User Manual

Page 32

background image

Using the System Setup Program: Dell OptiPlex GX1 Low-Profile Managed PC Systems

file:///C|/infodev/2013/eDoc/OpGX1/SQRG/system.htm[2/21/2013 11:52:58 AM]

Certain key combinations are not valid. If you enter one of these combinations, the speaker emits a
beep.

To erase a character when entering your password, press the key or the left-arrow key.

NOTE: To escape from the field without assigning a system password, press the key or
the key combination to move to another field, or press the key at any time
prior to completing step 5.

4. Press .

If the new system password is less than seven characters, the whole field fills with placeholders. Then
the option heading changes to Verify Password, followed by another empty seven-character field in
square brackets.

5. To confirm your password, type it a second time and press .

The password setting changes to Enabled. Your system password is now set; you can exit the System
Setup program and begin using your system. Note, however, that password protection does not take
effect until you reboot the system by pressing the reset button or by turning the system off and then on
again.

Using Your System Password to Secure Your System

Whenever you turn on your system, press the reset button, or reboot the system by pressing the
key combination, the following prompt appears on the screen when the Password Status
option is set to Unlocked:

Type in the password and...
- press to leave password security enabled.
- press to disable password security.
Enter password:

If the Password Status option is set to Locked, the following prompt appears:

Type the password and press .

After you type the correct system password and press , your system boots and you can use the
keyboard and/or mouse to operate your system as usual.

NOTE: If you have assigned a setup password (see "

Using the Setup Password Feature

"), the system

accepts your setup password as an alternate system password.

If a wrong or incomplete system password is entered, the following message appears on the screen:

** Incorrect password. **

Enter password:

If an incorrect or incomplete system password is entered again, the same message appears on the screen.