beautypg.com

When to run the icu, Preparing to use the icu – Dell OptiPlex G1 User Manual

Page 39

background image

Using the ISA Configuration Utility: Dell OptiPlex GX1 Low-Profile Managed PC Systems

file:///C|/infodev/2013/eDoc/OpGX1/SQRG/utility.htm[2/21/2013 11:53:00 AM]

Before your system was shipped from Dell, a technician used the ICU to enter the correct information for the
expansion cards initially installed in your computer.

If your system was shipped with Dell-installed software, the ICU diskette image (from which you can make an
ICU diskette) is installed on your hard-disk drive. (Your system may also be accompanied by an ISA
Configuration Utility Diskette
.)

The ICU is also available through online services such as Dell's TechConnect bulletin board service (BBS).
See your online System User's Guide or the chapter titled "Getting Help" in your Diagnostics and
Troubleshooting Guide
for information on accessing the BBS.

Whenever you add or remove a non-Plug and Play ISA expansion card, use the ICU to reconfigure your
system. The utility reads the card's corresponding configuration file (.cfg file), which describes the card's
characteristics and required system resources. After the resources identified in these configuration files are
assigned to all non-Plug and Play ISA expansion cards, the system assigns resources to all Plug and Play
expansion cards, as well as PCI expansion cards, thereby creating a conflict-free configuration.

ICU Database

The ICU provides a database of configuration files for a large variety of non-Plug and Play ISA expansion
cards. The database is located in the \db subdirectory. Listed cards are non-Plug and Play ISA expansion
cards that have configuration files stored in this database.

Unlisted cards are non-Plug and Play ISA expansion cards that do not have configuration files stored in the
ICU database. Unlisted cards are not displayed in the list of cards provided for the various card categories.
The unlisted cards may be cards for which no configuration file exists or new cards that include a
manufacturer-supplied configuration file on diskette.

When you supply a configuration file and the ICU is running from the hard-disk drive, the configuration file is
copied to the directory that contains the rest of the ICU database.

When to Run the ICU

Whenever you add or remove non-Plug and Play ISA expansion cards, you must run the ICU to ensure that
no two cards attempt to use the same resources (such as interrupt request [IRQ] lines).

Run the program before adding or removing any non-Plug and Play ISA expansion cards. The ICU can
identify and resolve any resource conflicts and indicate the proper jumper and switch settings for each
expansion card to avoid such conflicts. Running the program first helps you determine how to configure a
non-Plug and Play ISA expansion card before you install it in your computer.

After you have run the ICU for your non-Plug and Play ISA expansion cards and it has configured all your
Plug and Play and PCI expansion cards, you can use the utility to lock the configuration of your Plug and
Play and PCI expansion cards so that they are always assigned the same resources. See your online
System User's Guide or "

Locking and Unlocking Cards

" for details.

Preparing to Use the ICU

Before using the ICU for the first time, you must complete the following steps: