Dell 3130cn Color Laser Printer - Manual (Page 42)

To set or change the password that is required to access the printer's setup parameters from the Dell Printer Configuration Web Tool.
Set the password of the operator panel from Panel Lock in the Printer Settings. This page can also be displayed by clicking Set Password in the Left Frame.
NOTE: To restore the password to the default (NULL), initialize the non-volatile memory (NVM).
Values:
Administrator Password Sets the password using up to 10 alphanumeric characters. The password will appear as asterisks (*) in the field when it is entered.
Re-enter Administrator Password Enter the password again to confirm.
SSL/TLS
Purpose:
To specify the settings for the SSL encryption communication to the printer.
Values:
HTTPS
Select the check box to enable the HTTPS, and access is established using SSL communication.
Without setting Generate Self-Signed Certificate, you cannot select this check box.
Port Number Specifies the port number, which is not identical with that of HTTP for TCP/IP. This must be 443 or between 8000 and 9999.
Generate Self-Signed Certificate
Click to display Generate Self-Signed Certificate page and to create a security certification from the page.
Size of Public Key Select the size of public key.
Issuer Display the issuer of SSL self-signed certificate.
Generate Signed Certificate Click to generate the SSL self-signed certificate.
Manage Certificate
Click to display Manage Certificate page and to manage a security certification from the page.
Manage Certificate Display the SSL certificate information.
Delete Delete the SSL certificate.
Delete Certificate and Restart Printer Delete the SSL certificate and restart the printer.
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the printer.
Values:
Protocol Select the check box to enable the protocol.
IKE Use a preshared key for IKE authentication.
Pre-Shared Key Specifies a shared key.
Re-enter Pre-Shared Key Enter the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2880 minutes.
DH Group Selects the DH group.
PFS Selects the check box to enable the PFS setting.
Remote peers IPv4 address Specifies the IP address to connect to.
Remote peers IPv6 address Specifies the IP address to connect to.
Non IPsec communication policy Selects whether or not to communicate with a device which does not support IPsec.
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the Reset IPsec menu on the operator panel.
802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted communication to the printer.
NOTE: This item is only displayed when the optional network protocol adapter is installed, and also when the optional wireless printer adapter is not installed.