Dell 3130cn Color Laser Printer - Manual (Page 197)

2
2. After you replace the print cartridge, click Chart Print on
the Diagnosis tab.
3. Click the MQ Chart button.
The MQ Chart is printed.
Is the problem recovered?
The task is complete.
Contact
Dell.
Creased/stained paper
Action Yes No
1
Verify that the correct print media is being used. See "Supported Paper Sizes" . If not, use the
print media recommended for the printer.
Is the problem recovered?
The task
is
complete.
If
printing
on an
envelope,
go to
action 2.
2
Condensation inside the printer causes creased paper. Keep the printer turned on and leave it
more than one hour to get rid of the condensation. In winter, keep the printer turned on to
prevent condensation from forming. In this case, you can reduce power consumption by using
the energy-saving mode. If the problems still occur, contact Dell. See "Contacting Dell" .
The task
is
complete.
If
printing
on an
envelope,
go to
action 3.
3
Replace the fuser if you have a spare.
1. Replace the fuser. See "Replacing the Fuser" .
2. After you replace the fuser, test print your document again.
Is the problem recovered?
Contact
Dell.
Contact
Dell.
Jam/Alignment Problems
NOTE: Some of the following procedures that use the Tool Box can also be performed using the operator panel or
Dell Printer Configuration Web Tool. For information on how to use the operator panel and Dell Configuration Web
Tool, see "Understanding the Printer Menus" and "Dell Printer Configuration Web Tool" .
The top and side margins are incorrect.
Action Yes No