Cooper Instruments & Systems DFI INFINITY Digital Force Indicator/Controller - Manual (Page 80)

For Pot: __________
Reading Configuration “RDG.CNF”:
RDG.1=__ RDG.2=__ RDG.3=__ RDG.4=__
Reading Scale and Reading Offset “RDG SC” and “RDG OF”
Reading Offset “RDG OF”: ___________
(2-coordinate Format):
Count By “CNT BY”: ______
Alarm Number of Readings “AL RDG”: ____ ____
Setpoints Deadband “SP DB”: ______
Output Configuration “OUT.CNF”:
RDG.5=__ RDG.6=__ RDG.7=__
(Direct Format):
Reading Scale “RDG SC”: ___________
Reading Scale & Offset:
INPUT 1= __________ READ 1= __________
INPUT 2= __________ READ 2= __________
Input Configuration “IN CNF”:
INP.1=__ INP.2=__ INP.3=__ INP.4=__ INP.5=__ INP.6=__ INP.7=__
Input Scale and Offset “IN.SC.OF”:
INPUT 1: _________ READ 1: _________
INPUT 2: _________ READ 2: _________
Decimal Point “DEC PT” Position: F__F__F__F__F__F__
Filter Configuration “FIL.CNF”: FIL.1=__ FIL.2=__ FIL.3=__
Filter Time Constant “FIL TI”: ______
Setpoint Configuration “SP CNF”:
SPC.1=__ SPC.2=__ SPC.3=__ SPC.4=__ SPC.5=__ SPC.6=__ SPC.7=__ SPC.8=__
Alarm Configuration “AL CNF”:
ALC.1=__ ALC.2=__ ALC.3=__ ALC.4=__ ALC.5=__ ALC.6=__ ALC.7=__ ALC.8=__
Alarm Function “AL FNC”:
ALF.1=__ ALF.2=__ ALF.3=__ ALF.4=__
Alarms 1 & 2 Deadband “AL DB”: ______
OUT.1=__ OUT.2=__ OUT.3=__ OUT.4=__ OUT.5=__ OUT.6=__ OUT.7=__ OUT.8=__
Output Scale and Offset “OT.SC.OF”:
READ 1: ________ OUTPT 1: ________
READ 2: ________ OUTPT 2: ________
Baud Rate “BAUD”: _______
Serial Communication Configuration “SERCNF”:
SER.1=__ SER.2=__
CF 67 75 M1291/N/0403 11279ML-02 Rev. A