Great Plains V-300F Operator Manual - Manual (Page 61)

Great Plains Manufacturing, Inc. Monitor Operation 57
11/15/2007 148-057M-A
Turn Tramlining Off/On
With tramlining off:
• tramline bouts are not counted,
• tramline clutches do not operate, and;
• the default display becomes Forward Speed .
To disable Tramlining:
1. Power-off the console using its rear panel switch.
2. Press and hold the button.
3. While holding it, re-apply power, to enter Program
Mode 2 “CAL.2”.
4. Release and press to select the Tramline chan-
nel .
Refer to Figure 59
5.
Press the button to cycle between:
“1” = Tramlining On
“0” = Tramlining Off
6. Release all buttons. Remove and re-apply power to
save the selection. The instrument resumes normal
mode at next power-on.
Note: If tramlining is disabled, the indicator chevron skips
the channel during selection with .
Figure 59
Tramlining Off
22632