Great Plains V-300F Operator Manual - Manual (Page 60)

56 V300 & V300F Great Plains Manufacturing, Inc.
148-057M-A 11/15/2007
Normal Tramline Operations
Bout counting (resumption) and tramline clutch operation
commence automatically upon next forward movement
with the drill lowered. Bout counts at each lift operation.
Refer to Figure 56
In the figure, the drill is in bout 1 of a 4 bout cycle asym-
metrical tramline cycle (the decimal point between the
counts is on during Left or Right Asymmetrical tramlin-
ing).
During tramline bouts (passes where one or both tram-
line clutches operate), the console emits a beep at the
beginning of the bout, and the display flashes for the
duration of the bout.
Hold the Bout Number
Press to “hold” the current bout when the drill goes
out of work but has not completed the current bout.
The display flashes “StOP”.
Press again to resume the normal bout sequence.
Manually advance the bout number
Press to advance the current bout number by 1.
This feature works with tramlining active or stopped, but
does not exit “StOP” mode. To resume counting after
“StOP”, press
before or after .
Figure 56
Typical Tramline Display
22632
Figure 57
Bout Count Hold
22632
Figure 58
Increment Bout Count
22632