Great Plains V-300F Operator Manual - Manual (Page 36)

32 V300 & V300F Great Plains Manufacturing, Inc.
148-057M-A 11/15/2007
Tongue Transport Cylinder Lock
Refer to Figure 33
7.
Fully extend the tongue lift hydraulic cylinder.
8. Install the lock channel over the tongue cylinder rod.
it is stored on a lug just to the right of top center on
the hitch cross-beam.
Pivot Lock
Although used primarily for transport, the pivot locks may
also be engaged when drilling on steep slopes. They
keep the coulter/hitch rigidly aligned with the openers.
Refer to Figure 34
9.
Engage the pivot locks for transport. Remove the
pin. Flip the lock to the rear and re-insert the pin.
The pivot locks are behind the stabilizer cylinders on
each side of implement.
Walkboards
Refer to Figure 35
10. Swing up both walkboard ladders completely.
Ready for Transport
11. Know the implement dimensions in transport config-
uration. Choose a route that provides adequate
clearance from all obstructions. See “Specifications
and Capacities” on page 114.
12. Do not exceed 32 kph (20 mph).
13. Comply with all national, region and local laws when
travelling on public roads.
Figure 33
Tongue Cylinder Lock
22569
Figure 34
Pivot Lock
23151
23159
Figure 35
Walkboards
27196