Great Plains V-300F Operator Manual - Manual (Page 49)

Great Plains Manufacturing, Inc. Monitor Operation 45
11/15/2007 148-057M-A
Console Overview
There are three active switches on the front panel used
individually or in combination to program set/reset or
select a function. The two small outer buttons have no
function.
Current Channel Value
(in this case, kph or mph, as
Channel 1: Forward Speed
is selected)
Program Key Channel Select Stop Reset
• Select Area Total channel
then press to switch between
Area Total 1 and Area Total 2.
See page 51.
• Select Tramline Bout
channel, then press to man-
ually advance the Bout Number.
See page 55.
• Hold continuously to select
Program Mode 1. See page 46.
Reverts to Normal mode upon
button release.
• Hold while applying power to
enter Program Mode 2 “CAL.2”.
See page 46.
Channel
1
Forward Speed
2 Area Total 1 or 2
3 Current/Tramline Bout
4 Fertilizer Shaft RPM
5 Seed Shaft RPM
6 Hopper Level Low
Channel Select is also used to
select different values in some
menus.
• Press and release to over-
ride automatic advance of Tram-
line Bout number if drill is lifted,
then press and release
again to resume.
• Hold continuously to reset
currently displayed Area Total.
• Hold while applying power
for Program Mode 3 “CAL.3”.
See page 46.
Note: Holding down all three main buttons at power-on resets the instrument to factory defaults.
In addition to restoring some settings to values incorrect for V300, this also clears Grand Total Area to 0.
Chevron: Channel/In-Out of
Work Indicator
(in this case, Channel 1: For-
ward Speed is selected)
22632Power Switch on rear
22632
Power Switch on rear